RIFF JTAG – HTC Inspire 4G A9192 (HTC Stallion) Unbrick, Boot, IMEI, CID, ModelID, Unlock supported

HTC Inspire 4G A9192 (HTC Stallion) Unbrick, Boot, IMEI, CID, ModelID, Unlock supported

Resurrecting HTC Inspire is easy. Phone is auto powered on with USB Data Cable connected to the PC while battery is connected.
Some (or all) revisions of HTC Inspire boards have JTAG interface
disabled (that is enable MARM JTAG Fuse is blown in the MSM chip). In
this case the JTAG may be enabled only by firmware itself. This is done
by the FSBL loader, so writing to FSBL area is artificially disabled in
the DCC Loader code. DCC Loader will discard all flashing attempts into
FSBL zone and will respond with success code as if flashing succeeded.
In this way FSBL zone is protected while user still can flash full image
files seamlessly.
Resurrector will reflash radio’s boot zone (except FSBL area) and will re-write PDA’s SPL version 0.85.0024.
Additionally to SPL and Radio zones, the zone which contains Model ID
is re-flashed too. Thus after resurrection phone will have Model ID = ‘PD9812000’.
There is option to reflash BOOT and RECOVERY zones.
Please note, if your phone has the FSBL loader damaged and MCU has JTAG
FUSE blown then there is no way to resurrect your phone via JTAG
interface.

To resurrect HTC Inspire:

• Solder JTAG cable to HTC Inspire JTAG pads;
  
• Insert batter and connect USB Data cable;
  
• Make sure HTC Inspire is selected in the list of models;
  
• If you use only battery, press Power On key;
  
• Click Resurrect button;
  
• Wait till software signals a successful operation completion;
  
• Disconnect power supply, de-solder JTAG wires;
  

Now phone is in bootable condition, that is, even if it does not
start up normally you can flash it using known flashing methods.

To enter download mode:

• Disconnect PC cable;
  
• Insert battery;
  
• Hold ‘Volume Down’ key and press ‘Power ON’ button.
  

_